Bunn SET00.0198 FMD3 SST3 Hopper Powdered Drink Machine Cappuccino Display

$1,216.40

Bunn FMD3 SST, Model SET00.0198 Stainless Steel Cappuccino Display 3 4lb hoppers Brewing capacity: 4.2Gallons per hour •Variable speed motors allow control of product consistency in mixing chamber (0.75 to 6.6 grams of powder per second). •Lighted front graphics for merchandising are easy to exchange. •Attractive high-impact resin door is dent and scratch resistant. Black finish or stainless with black door. •Large easy-to-fill translucent hoppers hold 4 lbs. (1.81 kg) of product each, ensuring quick and timely refilling. •High speed heavy-duty whipper for complete product mixing. •Improved automatic rinsing of whipper reduces run-on after beverage is dispensed. •Adjustable legs and drip tray accommodate easily accessible through front and top. •International electrical configurations available. •Easy-to-program, one touch portion control for 3 cup sizes. •Fast fill perfect for quick service restaurants. •Each mixing chamber has independent powder to water ratio. •System setup password protected for safety. •Simple setup and hopper throw calibration system. •Black decor. •This product typically ships in 5 - 10 days. •Features, Options & Specifications Subject to Change Without Notice. Product Specifications •Bunn-o-Matic SET00.0198 Specifications •Crated Weight: 86.00 lbs. •Category: Specialty Drink Dispensers •Type: Hot Drink Machine •Bunn Model: FMD-3 SST •Product #: SET00.0198 •Volts: 120 •Amps: 15 •Total Watts: 1800 •Cord Attached: Yes (NEMA 5-15P) •Dimensions: 30" H x 11.3" W x 23.3" D •Brewing Capacity: based upon incoming water temp of 60° F. •Electrical: Models require 2-wires plus ground service rated 120V, single phase, 60 Hz. •Plumbing: 20-90 psi (138-621 kPa) from a 3/8" (10 mm) or larger supply line. A shut of valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied with 1/4" (6.4 mm) male flare fitting.

If you would like to have your machine installed for a fee in the lower 48 states by a Bunn technician the rate is $86.25 for installation, calibration, service, and removal, during business hours. Off business hours it is $129.38 and holidays $172.50.Travel are the same rates mentioned above and management fee is $30.00 per service event. If you are more than 50 miles outside the location of the nearest Bunn dealership there is an additional fee of $ 86.25 to the initial installation fee.

Can not be shipped Parcel Post


Add to Cart:

  • Model: SET00.0198 FMD SST
  • Shipping Weight: 86lbs
  • Manufactured by: Bunn-o-matic
  • Condition: new


Copyright © 2014 ARCO coffee company. Powered by Zen Cart
We're listed on ShopMania - Online Shopping